Scanning The Programmable Memory Channels; Band Edge Beeper - Yaesu FTM-7250DE Advance Manual

Scanning

Scanning the programmable memory channels

1. Press the [ V/M ( MW )] key to enter memory mode.
2. Turn the DIAL knob, or use the microphone keypad, to recall the upper or lower fre-
quency PMS memory channel (Ln or Un).
3. Press the [ # ] key on the MH-48A6JA Microphone.
"P1" appear on the right side of the display.
4. Press and hold [ UP ] or [ DWN ] on the microphone.
Programmable memory scanning will begin.
Note: To stop programmable memory scanning, press PTT on the microphone (this does
not cancel PMS mode).
To cancel PMS mode, when programmable memory scanning stops, press the [ # ]
key on the MH-48A6JA Microphone.

Band Edge Beeper

The FTM-7250DR/DE will automatically "beep" when the receive band edge is encoun-
tered during scanning (either in standard VFO scanning or during PMS operation). Ad-
ditionally, the band edge beep feature may be enabled to sound when the band edge
frequency is reached while tuning the VFO, using the DIAL knob.
The procedure to enable the Band-Edge Beeper (during manual tuning) is:
1. Press and hold the [ MHz ( SETUP )] key, then rotate
the DIAL knob to select "BEP EDGE 4".
2. Press the [ MHz ( SETUP )] key, and then rotate the
DIAL knob to set this Menu item to "ON".
3. Press and hold the [ MHz ( SETUP )] key to save the
new setting and exit to normal operation.
23