Table of Contents
Advertisement
3Installing the option devices
3.2 Installation of hand tube
The installation procedure of the hand tube is as follows. In use of solenoid valve set and hand input cable
optional, please operate with referring to the
Installing the hand input cable"
And, operate after turning OFF the power supply of the drive unit.
<1> Motor cover J3
<3> Piping fixing bracket
The grease is applied.
<5> Fixing place (two places)
(Rubber sheet + cable tie)
<2> Secondary piping air coupling
(φ4 x 4 places)
Insert the union installation side.
<6> Fixing place (tool side)
(Rubber sheet + cable tie, etc)
Fig.3-4 ： Installation of the hand tube
The procedure is shown below.
Installation of hand tube
3-48
together.
*1
Hand tube
Page 44, "3.1 Installing the solenoid valve set"
*The position of the J3 axis and the J4 axis
J3 = upper end
J4 = 0 degree
and the
CAUTION
*1) Adjustment of the fixing position
In the condition that the J3 axis is upper
limit and the J4 axis is 0 degree, align the
top of air tube with the upper end of the
Piping fixing bracket.
<4> Shaft
The grease is applied.
Page 52, "3.3
Advertisement
Table of Contents
