Lubrication Method; Lubrication Method To The J1, J2 Axis; Lubrication Method To The Shaft - Mitsubishi RH-3SQHR3515 Instruction Manual

Table of Contents

Advertisement

(2) Lubrication method

1) The positions of lubrication ports are shown in the
supply the grease easy.
2) Refer to
Page 65, "5.3.2 Installing/removing the
3) Insert the grease shown in
4) Install the covers with the removal procedure in reverse.
CAUTION

(3) Lubrication method to the J1, J2 axis

1) Refer to
Page 65, "5.3.2 Installing/removing the
2) Insert the grease shown in
specified amount of grease. Adding excess grease may cause grease to leak.
3) The J1 axis has the grease nipple and the timing belt in the near position. Although the timing belt is using the
oil-resistant belt, if the grease adheres, please wipe it off.
4) Install the covers with the removal procedure in reverse.

(4) Lubrication method to the shaft

1) Refer to
Page 65, "5.3.2 Installing/removing the
2) Wipe the old grease off the shaft. At this time, wipe off the grease that has been scattered inside the motor
cover J3 and the bracket attached vertically to the shaft fastening area.
3) Apply the specified amount of grease to the shaft. If too much grease is applied, grease may get scattered
all over inside of the No. 2 arm. If the grease reaches the timing belt inside the No. 2 arm, the timing belt
may deteriorate prematurely.
4) Install the covers with the removal procedure in reverse.
Table 5-4
using a grease gun from the lubrication grease nipple.
Use manual grease gun, and inject grease with pressure 0.03Mpa or less. Do not use
the grease gun, which derived by the factory air presser to avoid injecting by too high
pressure.
Table 5-4
using a grease gun from the lubrication grease nipple. Add only the
Fig.
5-9. Move the robot to the posture in which it can
cover", and remove the covers necessary.
cover", and remove the covers necessary.
cover"," remove the motor cover J3.
Maintenance and inspection procedures 5-75
5Maintenance and Inspection

Advertisement

Table of Contents
loading

Table of Contents