Table of Contents
Advertisement
Note : Please see the hand output cable from the arm cover A (2) <4> side, and store it outside the bracket. If
the cable enters within the bracket, it will rub to the timing belt and will become the cause of breaking
down.
Fig.3-10 ： Storing of the hand output cable
5) Install the No.2 arm cover <3> and arm cover A (2) <4> as before. Be careful not to catch any the cables.
6) Connect to the solenoid valve of customer preparation the hand output cable taken out from No.2 arm cover
<2>
The installation of the hand output cable is completion above.
Bracket
Cable should be stored in
outside of the bracket.
Ａ
3Installing the option devices
View from A
(Arm cover A(2) <13> side)
Installing the hand output cable 3-55
Advertisement
Table of Contents
