Installing The Base Cover B(L) - Mitsubishi RH-3SQHR3515 Instruction Manual

<ORIGIN> DATA
J1( 06DTYY) J2( 2?HL9X) J3( 1CP55V)
J4( T6!MSY) J5( Z21J%Z) J6( A12%Z0)
J7( ) J8(
ABC
<ORIGIN> DATA
CHANGE TO ORIGIN. OK?
Yes
123
◇◆◇ Moving the cursor ◇◆◇
Press the [ ↑ ], [ ↓ ], [ ← ] and [ → ] keys.
◇◆◇ Inputting characters ◇◆◇
Press the [CHARACTER] key and set to the character input mode. (Condition that "ABC" was
displayed under the screen). The displayed character is scrolled each time at pressing the key.
◇◆◇ Correcting an input ◇◆◇
After returning one character by pressing the [ Ｃ Ｌ Ｅ Ａ Ｒ ] key, input the character again.

(6) Installing the base cover B(L)

base cover B(L)
Return the
This completes the setting of the origin with the origin data input method.
WARNING
◇◆◇ If the origin input data is incorrect ◇◆◇
If the origin input data is incorrect, the alarm No. 1760 (origin setting data illegal) will occur when origin data input.
In this case, reconfirm the value input for the origin data.
D:( V!%S29)
)
CLOSE
No
.
removed in section
Always remove and install the cover with the controller power turned OFF. Failure
to do so could lead to the robot moving because of incorrect operations, or to
physical damage or personal injury.
5) After inputting all of the values, press the [EXE] key. The
origin setting confirmation screen will appear.
6) Press [F1] (Yes) to end the origin setting
Page 19, "(1) Confirming the origin data"
2Unpacking to Installation
to its original position.
Setting the origin 2-23