Table of Contents
Advertisement
ATTACHMENTS AND OPTIONS
(9) Pre-set 1st Attachment line pressure limit (Bar)
(10) Pre-set 1st Attachment line flow rate (l/min)
(11) Pre-set 2nd Attachment line flow rate (l/min)
(12) Monitor status
CHANGING ATTACHMENT PRE-SET
1.
Using buttons (2) and (5) scroll to the required attachment
pre-set.
Note: 1 button = 1 menu movement
2.
Once the required attachment pre-set is selected press
button (3) Enter to confirm selection or press button (1)
Esc to return to the current pre-set attachment.
k
k
If the breaker operations are performed in a mode other
than the breaker mode, there is a danger of breakage of
the hydraulic equipment. Do not perform operations in any
mode except the breaker mode see METHOD FOR SE-
LECTING WORKING MODE (3-193)
NOTICE
When this tool control system is fitted the factory flow set-
ting on the machine will be set to minimum, do not adjust
this value as doing so will have no effect on the attach-
ment performance.
NOTICE
When operating in P, E or L mode select ATTACHMENT 16
OFF as the attachment pre-set, this will deactivate the at-
tachment controls for standard digging or lifting opera-
tions.
CAUTION
ATTACHMENTS AND OPTIONS
6-61
Advertisement
Table of Contents
