Table of Contents
Advertisement
EXPLANATION OF COMPONENTS
F5: Returns the screen to the Attachment Setting screen without changing the name.
F6: Enters the change and returns to the Attachment Setting screen.
It is not possible to change the name for "No Attachment" setting.
Changing "2-Way Attachment Oil Flow Rate Setting"
1.
Select an attachment setting to change its oil flow rate on
the "Attachment Setting" screen, then press switch F2.
2.
The "2-Way Attachment Oil Flow Rate Setting" screen is
displayed.
On the "2-Way Attachment Oil Flow Rate Setting" screen,
you can perform the following operations with switches F3
to F6.
F3: Decreases the flow by 1 level.
F4: Increases the flow by 1 level.
F5: Returns to the "Attachment Setting" screen without
changing the oil flow rate.
F6: Enters the oil flow setting and returns to the "Attach-
ment Setting" screen.
(X): Present oil flow setting
(Y): Min. adjusted oil flow
(Z): Max. adjusted oil flow
It is not possible to change the oil flow for "No Attachment" setting.
ATTACHMENT SETTING 2
If installing 2nd attachment lines as a field kit ask your Komatsu distributor to change the monitor setting to allow
2 attachments (as shown below).
On machines equipped with 2 attachment lines it is possible on the attachment 2 settings menu to adjust the oil
flow in ATT mode to match the attachment installed.
Changing Attachment Oil Flow Setting
1.
When attachment 2 is set, the oil flow in ATT mode screen
shows as the drawing on the right. Select the oil flow set-
ting to be changed and press switch F2.
(a) Oil flow in attachment 1
(b) Oil flow in attachment 2
3-72
OPERATION
Advertisement
Table of Contents
