Table of Contents
Advertisement
MACHINE OPERATIONS AND CONTROLS
REMARK
When cleaning the stains deposited on the monitor surface such as dusts, brush them off with a clean, soft
and dry cloth.
For sticky dirt such as oil, remove it with glass cleaner for family use on the market (weakly acid to weakly
alkaline, containing no abrasive), and then finish-wipe with a clean, soft, and dry cloth.
10. Check and clean the rearview mirrors.
Check for damage to the rear view mirror. If it is damaged, repair it. Clean the surfaces of the mirrors and
adjust the angle so that the area at the rear can be seen from the operator's seat.
11. Check the seat belt and mounting hardware.
Check the seat belt and mounting hardware for any abnormality. If any damage is found, ask your Komatsu
distributor to replace it with new one.
12. Check the bucket with hook (if equipped) for damage.
Check for damage to the hook, guide, and hook mount. If any problem is found, ask your Komatsu distribu-
tor for repair.
13. Check and clean the camera
Check the camera for any abnormality. If any problem is found, ask your Komatsu distributor for repair.
14. Remove dirt from around the aftertreatment devices.
Check for dirt and combustible materials (dry leaves, twigs, etc.) accumulated around the aftertreatment de-
vices. If any dirt or combustible materials are found, remove them.
15. Check around the aftertreatment devices for exhaust gas leakage.
Check the pipe connecting the turbocharger to the aftertreatment devices and also KDPF connections for
leakage of exhaust gas (and deposition of soot). If any problem is found, ask your Komatsu distributor for
repair.
16. Check around SCR for exhaust gas leakage.
Check the pipe between the KDPF and SCR and also the SCR connections for leakage of exhaust gas
(and urea deposit). If any problem is found, ask your Komatsu distributor for repair.
METHOD FOR CHECKING BEFORE STARTING
Always check the items in this section before starting the engine each day.
REFUELLING PUMP
When adding fuel, never spill the fuel or let it overflow. It will cause a fire.
If any fuel has spilled, wipe it up completely. If the fuel has spilled over soil or sand, remove that soil or
sand.
Fuel is highly flammable and dangerous. Never bring flames near fuel.
Ensure that the machine is parked on level ground during refuelling operation.
Do not leave machine unattended during refuelling and monitor.
Following any over filling or spillage of fuel, inspect machine to ensure no fuel remains near electrical
or high temperature components.
Do not run refuel pump dry. Monitor fuel level in barrel during refuelling to prevent pump running dry.
The fuel pump is protected by an in-line blade fuse. If the pump fails to function - check the fuse.
Ensure the strainer on the hose end is clean.
When not in use, fully close the hose strainer valve cap to prevent leakage or spillage.
If there is any malfunction of the refuel automatic shut-off system, consult your Komatsu distributor and
do not use the system until the problem is rectified.
3-142
k
k
WARNING
k
k
CAUTION
OPERATION
Advertisement
Table of Contents
