Table of Contents
Advertisement
OPERATION
4.
Set the fuel control dial to Low idle (MIN) position.
5.
Press switch F6 to display the "Aftertreatment Devices Re-
generation" screen.
6.
Select manual stationary regeneration, check again that there is no person or combustible material around
the machine, then press switch F6.
If the machine needs to be moved again to secure safety, move it to a safe place and repeat the procedure
from step 1.
REMARK
After switch F6 is pressed in step 6, the screen shown in
the figure may be displayed. This indicates that the opera-
tions in steps 1 to 4 were not performed correctly or there
is trouble other than KDPF soot accumulation abnormality.
Check that the engine is running normal, the lock lever is
in LOCK position (L), and the fuel control dial is in Low idle
(MIN) position, then repeat the procedure from step 6.
If the manual stationary regeneration still cannot be per-
formed, return to the standard screen, press switch F5 to
check the contents of other occurring troubles, stop the
work and perform inspection and maintenance.
EXPLANATION OF COMPONENTS
3-117
Advertisement
Table of Contents
