Table of Contents
Advertisement
TRANSPORTATION
1.
Apply the brake of the trailer securely.
2.
Set chocks (1) to the wheels to secure the trailer.
3.
Set right and left ramps (2) parallel to each other and
equally spaced to the right and left of center (3) of the trail-
er. Make angle of installation (4) a maximum of 15°.
If the ramps bend a large amount under the weight of the
machine, put blocks under the ramps to prevent them from
bending.
4.
Remove the chains and wire ropes fastening the machine.
5.
Start the engine.
Warm the engine up fully in cold weather.
6.
Set the lock lever to FREE position (F).
7.
Push travel speed selector switch (5) to set the travel
speed to low (Lo lights up).
The travel speed (Lo, Mi, Hi) is displayed on travel speed
display (6).
8.
Turn auto-deceleration switch (7) OFF and operate the fuel
control dial to set the engine to low speed.
Each time auto-deceleration switch (7) is pressed, it
switches OFF to ON to OFF in turn.
When auto-deceleration switch (7) is turned OFF, the auto-
deceleration pilot lamp (8) goes out.
9.
Raise the work equipment and move slowly.
10. When the machine is horizontal on the top of the rear end
of the trailer, stop the machine.
3-248
OPERATION
Advertisement
Table of Contents
