Stratasys Fortus K5 Series Site Preparation Manual page 2

LIABILITY STATEMENT
The information in this document is subject to change without notice.
Stratasys, Inc. makes no warranty of any kind with regard to this material, including, but not
limited to, the implied warranties of merchantability and fitness for a particular purpose.
Stratasys, Inc. shall not be liable for errors contained herein or for incidental or consequential
damages in connection with the furnishing, performance, or use of this material.
This document is protected by copyright. All rights reserved. Its use, disclosure, and possession are
restricted by an agreement with Stratasys per software copyright. No part of this document may be
photocopied, reproduced or translated into another language without the prior written consent of Stratasys,
Inc.
All drawings and information herein are the property of Stratasys Inc. All unauthorized use and reproduction
is prohibited.
TRADEMARK ACKNOWLEDGMENTS
Stratasys, Insight, FORTUS, and FDM are registered trademarks of Stratasys, Inc.
FORTUS 380mc and 450mc are a registered trademark and service mark of Stratasys Inc. in the United
States and other countries.
ULTEM™ is a registered trademark of SABIC or affiliates or subsidiaries.
All other product names and trademarks are the property of their respective owners, and Stratasys assumes
no responsibility with regard to the selection, performance, or use of these non-Stratasys products. Product
specifications subject to change without notice.
ii