Stratasys Fortus K5 Series Site Preparation Manual page 18

To remove the rear top cover:
1. Open the rear top cover. Disconnect the electrical wiring for the rear top cover cooling fans by
pulling the connectors apart
2. Using a 4 mm Allen wrench, remove the p-clamp mounting screws (2) from the upper p-clamps
(Figure 11).
3. Using a 5 mm Allen wrench remove the p-clamp mounting screws (2) from the lower p-clamps
(Figure 11).
Disconnect
Fan Cables
(2)
4. Using a 4 mm Allen wrench, remove the rear top cover slider stop bolt (1)
(Figure 11).
Figure 11: Disconnect Fan Wiring & P-Clamps
Figure 12: Disconnect Stop Bolt
14
Remove using a
4 mm Allen wrench (2)
Remove using a
5mm Allen wrench
(2)
(Figure 12).