Stratasys Fortus K5 Series Site Preparation Manual page 16

Foam Insert
2. Remove the foam restraining insert between the ramp and the printer
Caution: Use care when cutting the plastic bag to avoid scratching the printer's
surfaces.
3. Remove all tape and carefully cut the plastic bag encasing the printer. Unwrap the printer by pulling
the plastic bag downward.
4. Ensure that the bag is not blocking the ramp or the printer's casters. If needed, cut away the plastic
bag's material from the exit side of the ramp to ensure that the printer can roll freely down the ramp.
5. Carefully roll the printer from the shipping base using the ramp.
Note: When removing the printer it is recommended that one person guide each
side, while a third person support the front of the printer (to ensure that the oven
door and canister bay doors do not open).
6. Inspect the printer's exterior for dents and scratches. Immediately report any damage to Stratasys
and the shipping company.
7. Roll the printer into its approximate operating location.
Note: Position the printer to allow at least three feet of clearance on all sides until
the installation process is complete, see
installation and setup must be accomplished by a qualified service representative.
Figure 9: Ramp Down Detail
"Space Requirements" on page 2
12
(Figure 9).
Final
.