Preparing The Server For Installation - HP HPE ProLiant DL365 Gen10 Plus Server User Manual

Preparing the server Preparing the server for installation
Procedure Procedure
1. Observe the following warnings:
WARNING: The front panel Power On/Standby button does not shut off system power. WARNING:
Portions of the power supply and some internal circuitry remain active until AC power is
removed.
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove
power from the server:
For rack and tower servers, remove the power cord.
For server blades and compute modules, remove the server blade or compute module
from the enclosure.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the WARNING:
internal system components to cool before touching them.
2. Update the system ROM.
Locate and download the latest ROM version from the Hewlett Packard Enterprise Support Center website
(https://www.hpe.com/support/hpesc https://www.hpe.com/support/hpesc). To update the system ROM, follow the instructions on the website.
3. Power down the server.
a. Shut down the OS as directed by the OS documentation.
b. To place the server in standby mode, press the Power On/Standby button. When the server enters standby power mode, the
system power LED changes to amber.
c. Disconnect the power cords (rack and tower servers).
4. Do one of the following:
Depending on your product, extend or remove the server from the rack.
Remove the server from the enclosure.
5. If removed, place the server on a flat, level work surface.
6. Remove the access panel.
7. Remove any options or cables that might prevent access to the TPM connector.
8. Proceed to "Installing the TPM board and cover."
for installation

Preparing the server for installation

148