Installing An Energy Pack - HP HPE ProLiant DL365 Gen10 Plus Server User Manual

Installing an energy pack

Installing an energy pack
Prerequisites Prerequisites
Before installing this option, be sure you that have the components included with the hardware option kit.
Procedure Procedure
1. Power down the server ( Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
4. Remove the access panel .
5. Install the energy pack and connect the energy pack cable.
IMPORTANT: IMPORTANT:
To enable SmartCache or CacheCade in a P-class type-p Smart Array controller, you must:
Connect the controller backup power cable to the controller backup power connector on the system or riser
board.
Connect the energy pack cable to the energy pack connector on the system board.
Installing an energy pack 141