Installing An Hpe Smart Array P816I-A Sr Gen10 Controller Option - HP HPE ProLiant DL365 Gen10 Plus Server User Manual

Installing an HPE Smart Array P816i-a SR Gen10 Controller option

Installing an HPE Smart Array P816i-a SR Gen10 Controller option
Prerequisites Prerequisites
Before installing this option, be sure that you have the following:
The components included with the hardware option kit
Additional cables, as required. For more information, see Cabling
T-15 Torx screwdriver
Procedure Procedure
1. Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the WARNING:
internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any CAUTION:
installation procedure. Improper grounding can cause electrostatic discharge.
2. Back up all server data.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
6. Remove the access panel .
7. Install the controller.
8. Connect the cables.
The following illustration shows the 8+2 SFF backplane configuration connected to the controller. Additional cabling options are
available.
Installing an HPE Smart Array P816i-a SR Gen10 Controller option 116