Installing A 2 Sff Sas/Sata Drive Cage - HP HPE ProLiant DL365 Gen10 Plus Server User Manual

Installing a 2 SFF SAS/SATA drive cage

Installing a 2 SFF SAS/SATA drive cage
Prerequisites Prerequisites
Universal media bay options are compatible only with the 8 SFF chassis.
Hewlett Packard Enterprise recommends installing the P816i-a controller to support 10 SAS/SATA drives. However, additional
controller options are available. For more information, see Installing an HPE Smart Array P816i-a SR Gen10 Controller option .
In addition, be sure that you have the following:
The components included with the hardware option kit
T-10 Torx screwdriver
Additional cables, as needed. For more information, see SFF cables.
2 SFF SAS or SATA drives or blanks
For more information, contact a Hewlett Packard Enterprise authorized reseller.
Procedure Procedure
1. Back up all server data.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the access panel .
6. Remove the universal media bay blank.
7. Install the 2 SFF SAS/SATA drive cage.
Installing a 2 SFF SAS/SATA drive cage 80