Confirming The Software And Firmware Configurations - Fujitsu Oracle M10-1 Service Manual

The following is an example of executing the showhardconf command.
XSCF> showhardconf -M
SPARC M10-1 ;
+ Serial:21xxxxxxxx; Operator_Panel_Switch:Service;
+ System_Power:Off; System_Phase:Cabinet Power Off;
Partition#0 PPAR_Status:Powered Off;
MBU Status:Normal; Ver:2209h; Serial:TZ01348006 ;
+ FRU-Part-Number:CA07363-D011 A0
+ Power_Supply_System: ;
+ Memory_Size:1024 GB; Type: B ;
CPU#0 Status:Normal; Ver:4141h; Serial:00010263;
+ Freq:3.200 GHz; Type:0x20;
+ Core:16; Strand:2;
MEM#00A Status:Normal;
+ Code:ce8001M386B8G70BO0-YH94 0000-2151EFEB;
+ Type:47; Size:64 GB;
MEM#01A Status:Normal;
+ Code:ce8001M386B8G70BO0-YH94 0000-2151EF8A;
+ Type:47; Size:64 GB;
*1 For an MBU on which the SPARC64 X+ processor is mounted, "Type: B" is displayed. For an MBU on which the
SPARC64 X processor is mounted, "Type: A" is displayed.
*2 If the SPARC64 X+ processor is mounted, "2.800 GHz; Type:0x20", "3.200 GHz; Type:0x20", or "3.700 GHz;
Type:0x20" is displayed.
If the SPARC64 X processor is mounted, "2.800 GHz; Type:0x10" is displayed.
*3 If the SPARC64 X+ (3.7 GHz (8 cores)) processor is mounted, "Core:8" is displayed.
4.1.2 Confirming the software and firmware
configurations
The software and firmware configurations and versions affect system operation. To
change the configuration or investigate a problem, check the latest state and check for
any problems in the software.
Confirming the software configuration
Use Oracle Solaris commands to check the software configuration.
If you are logged in to the XSCF console, switch to the control domain console by
executing the console command beforehand.
Table 4-1
30 Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021
(Omitted)
lists the commands used for checking the software configuration.
/7088702
(*1)
(*2)
(*3)
;