Identifying A Failure - Fujitsu Oracle M10-1 Service Manual

Figure 4-1 Troubleshooting flow
Confirm that an error message is
displayed on the OS and XSCF
consoles.
Execute showlogs on XSCF to
display failure information.
Check /var/adm/messages on
Oracle Solaris.
Write down the displayed failure
information.
Contact our service engineer.
4.2.2

Identifying a failure

This section describes how to identify a failure. Use the flow described in
Confirming whether there is a
for a failure.
Checking the LED indications
Check the LEDs on the operation panel, rear panel, and each component to identify
the FRU requiring maintenance. Check the status of a FRU from its LED before
starting maintenance work on the FRU.
Operation panel LEDs
■
Start
Are the power OK
and AC OK LEDs off?
NO
Was e-mail sent by
the XSCF mail function?
NO
End
YES
YES YES
failure" to determine the appropriate way of checking
Chapter 4 Preparation and Precautions for Maintenance
Is the power cord
connected correctly?
NO
Connect the power
cord correctly.
"4.2.1
35