Switching On For The First Time: Installing The Software; Switching On Monitor And Device - Fujitsu CELSIUS W4 Series Operating Manual

Switching on for the first time: installing the software
Installing, Software, Installing,
Once the installation has been started the device must not be switched
off, unless the installation has been completed.
During installation, the device may only be rebooted when you are requested to do so!
The installation will otherwise not be carried out correctly and the contents
of the hard disk must be completely restored.
If the device is integrated into a network, the user and server details as well as
the network protocol are required during the software installation.
Contact your network administrator if you have any questions about these settings.
When you switch on the device for the first time, the supplied software
is installed and configured. Plan a reasonable amount of time for this,
as this process must not be interrupted.
You may need the licence number for Windows during the installation. The licence
number is located on a sticker on your device.

Switching on monitor and device

Device, Monitor,
In order to avoid overheating, do not cover the ventilation areas of the monitor
or the device, see
► Switch the monitor on (see the operating manual for the monitor).
► Switch the device on. To do this, follow the instructions below.
Switching on the device
► Press the ON/OFF switch on the front of the device.
The ON/OFF switch and the illumination strip light up white and the device starts up.
Fujitsu Technology Solutions
"Setting up the device", Page 13.
Getting started
19