Accessing A Fru; Removing The Power Cords - Fujitsu Oracle M10-1 Service Manual

2 /FAN#1
3 /FAN#2
4 /FAN#3
5 /FAN#4
6 /FAN#5
7 /FAN#6
------------------------------------------------------------------------------
Select [1-7|b:back] : 7
5. After confirming that the selected FRU is displayed, enter [r].
You are about to replace FAN#6.
Do you want to continue?[r:replace|c:cancel] : r
Confirm that the CHECK LED of the FRU is blinking.
6.
For the CHECK LED location, see
Please execute the following steps:
1) Confirm the Check LED is blinking.
2) Remove FAN#6.
3) Execute either the following:
3-1) After installing the exchanged device, please select 'finish'.
3-2) If you want to suspend the maintenance without exchanging device,
please select 'cancel'.
[f:finish|c:cancel] :
You can now start FRU maintenance. Do not enter "f" until you complete the
maintenance work.
After replacing the FRU, perform the work in
System with the replacefru
5.8

Accessing a FRU

This section describes the operations to be performed before accessing the FRU
requiring maintenance. The required operations vary depending on the FRU
requiring maintenance.
5.8.1

Removing the power cords

Remove the cable clamp from each power cord, and then remove the power cords.
Release the latch (A in
1.
Pulling the cable clamp toward the rear of the chassis facilitates the release of the
latch.
58 Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021
Normal
Normal
Normal
Normal
Normal
Faulted
Command" to incorporate the FRU into the system.
Figure 5-1) of the cable clamp.
"2.4.3 LEDs on each component."
"6.2 Incorporating a FRU into the