Fujitsu Oracle M10-1 Service Manual page 4

Chapter 4 Preparation and Precautions for Maintenance 29
Chapter 5 Preparations Required for Maintenance 45
iv Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021
3.1 Types of Maintenance Supported in the SPARC M10-1 25
3.2 Active Maintenance 26
3.3 System-stopped Maintenance (Inactive Maintenance) 27
4.1 Confirming the System Configuration 29
4.1.1 Confirming the hardware configuration 29
4.1.2 Confirming the software and firmware configurations 30
4.1.3 Confirming the FRU information and resource information 33
4.2 Troubleshooting 34
4.2.1 Confirming whether there is a failure 34
4.2.2 Identifying a failure 35
4.2.3 Downloading error log information 40
4.3 Maintenance Precautions 41
4.3.1 Precautions for replacement 41
4.3.2 Precautions for expansion 43
4.3.3 Precautions for reduction 44
5.1 Preparing Tools Required for Maintenance 45
5.2 Switching the Mode Switch to Service Mode 46
5.3 Checking the Operating Condition and Resource Usage Status 46
5.3.1 Checking the operating condition of the physical partition or
logical domain 46
5.3.2 Checking the assignment status of I/O devices 47
5.3.3 Checking the usage status of the internal disk 48
5.4 Enabling the Removal of an Internal Disk 48
5.4.1 How to identify a disk slot 49
5.4.2 Releasing an internal disk from the system 51
5.5 Stopping the Entire System 52
5.5.1 Stopping the system with the XSCF command 52
5.5.2 Stopping the system from the operation panel 53
5.6 Saving Setting Information and Configuration Information 54