Setting The Feed Dog Height At Top Dead Center - Dürkopp Adler 967 Service Instructions Manual

Setting the feed dog
Setting steps
1. Set the upper stitch length adjusting wheel to the maximum stitch length.
2. Loosen the setscrews (1).
3. Put the handwheel into the 190° position.
4. Press the stitch adjustment lever (3) downwards and observe the feed
5. Turn the pusher eccentric (2) such that the feed dog and needle no
6. Tighten the setscrews (1).

8.2.2 Setting the feed dog height at top dead center

The feed dog reaches the maximum stroke height at top dead center when
the position of the handwheel is 190°.
Correct setting
Place the feed dog in the uppermost position by turning the handwheel.
 The upper edge of the feed dog protrudes 1.3 mm above the throat
Cover
• Tilt the upper section ( page 10).
Figure30: Setting the height of the feed dog
(1) - Feed dog carrier
Service instructions 967 - 00.0 - 12/2014
dog and needle as you do so.
longer move when the stitch adjustment lever (3) is pressed.
WARNING
Risk of injury!
Crushing injuries from moving parts.
Switch off the sewing machine before checking and
setting the feed dog height.
plate.
(2) - Setscrew
43