Settings Relating to Signal Outputs (Output
Menu)
To make settings relating to DME output signals, display the DME >Output
menu.
To display the Output menu
In the Engineering Setup menu, select VF4 'DME' and HF3 'Output.'
These settings are possible only when the DME is an MVE-9000 or SDI-
interfaced MVE-8000A.
The following functions are available here.
• Monitor Output: Set the signals output from the four monitor output
connectors.
• Clip Adjust: Adjust the clip level of DME2 output.
Adjusting the Monitor Output
When the MVE-8000A/MVE-9000 is connected through SDI interface, you
can adjust DME2 output video clip level.
Use the following procedure.
1
In the <DME2(Ch5-Ch8)> group of the DME >Output menu, press [Clip
Adjust], turning it on.
2
Set the following parameters.
Knob
1
2
3
To return the setting to the default value
In the DME >Output menu, press [Default].
Parameter
Adjustment
White Clip
White clip adjustment
Dark Clip
Dark clip adjustment
Chroma Clip Chroma clip adjustment
Settings Relating to Signal Outputs (Output Menu)
Setting values
90.00 to 109.02
−6.85 to +10.00
90.00 to 113.17
173