Knob
3
3
Press [Table Assign Set].
This sets the table for the selected switcher bank or bus.
Exporting Source Names and Destination Names
To send the source names and destination names to the S-Bus, use the
following procedure.
1
In the Panel >XPT Assign menu, press [Name Export].
The Name Export menu appears.
2
Turn the knob to set the station ID.
Knob
1
a) If set to 255, the information is sent to all stations (with display of "All").
3
Press [Src Name Export].
This exports the source names to the station selected in step 2.
4
Press [Dest Name Export].
This exports the destination names to the station selected in step 2.
Note
Since destination names cannot be selected freely, fixed names are used.
Parameter
Table No
Parameter
Adjustment
Station ID
Station ID setting
Adjustment
Values
Selection of table
1 to 15
to be assigned
Setting values
1 to 255
Cross-Point Settings (Xpt Assign Menu)
a)
83