Setting The Extention Board To Be Activated; Adjusting The Extension Board - Sony PC-3000 Operating Instructions Manual

Setting the Extention Board to
be Activated
You can select the extension board to be activated.
1
Turn on the power.
2
Press the CONTROL button.
3
Press the > or . button until the CONTROL
MENU EXB SETTING display appears.
CONTROL MENU
EXB SETT I NG
4
Press the SET button.
EXB SET T I NG >SLOT1
>CH 1–2 >EXB-5010
5
Press the ? or / button to flash CH1-2 (ex. "1-
2") .
6
Press the > or . button to display the channel for
the extension board.
EXB SET T I NG >SLOT1
>CH 1–3 >EXB-5010
7
Press the ? or / button to flash EXB-5010.
8
Press the > or . button to select the setting.
When you activate the extension board in the
selected channel: display EXB-5010.
When you do not activate the extension board in
the selected channel: display NOT USED.
EXB SET T I NG >SLOT1
>CH 1–3 >NOT USED
Notes
In the following cases, the EXB SETTING display
does not appear:
• When the extension board is not mounted.
• When the RGB/MIX switch of the IFB-12/12A is not
set to RGB.
When selecting the channel where the
interface board is mounted but the
extension board is not
"INVALID" appears.
Adjusting the Extension
Board
When you use the extension board, you can adjust
the COLOR, HUE, and SHARP (sharpness). You
can also select the output of the Sync on Green
signal.
1
Turn on the power.
2
Press the CONTROL button.
3
Press the > or . button until the CONTROL
MENU EXB CONTROL display appears.
CONTROL MENU
EXB CONTROL
4
Press the SET button.
–
CH 1 8 >COLOR MIN
>HUE MIN >SHARP MIN
5
Press the ? or / button to flash the item to
be adjusted.
6
Press the > or . button to adjust the item.
You can adjust between MIN, 1,2, ...., 98, 99
and MAX.
> button: press to increase the level.
. button: press to decrease the level.
–
CH 1 8 >COLOR 20
>HUE MIN >SHARP MIN
19
(EN)