Xantrex Freedom XC2000-230V Owner's Manual page 52

Basic Installation Procedures
WARNING
ELECTRICAL SHOCK HAZARD
Tighten the nuts on the DC terminals properly. Loose
n
connections cause excessive voltage drop and may
cause overheated wires and melted insulation.
Do not over-tighten the nut on the DC input terminals
n
because damage to the DC input terminals may result.
Use a torque screwdriver to tighten the nut to a maximum
torque of 9 N-m of force.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
NOTICE
REVERSE POLARITY
Check cable polarity at both the battery and the Freedom
n
XC before making the final DC connection. Positive must
be connected to positive; negative must be connected to
negative.
Reversing the positive and negative battery cables will
n
blow a fuse in the Freedom XC and void your warranty.
Failure to follow these instructions can result in equipment
damage.
36
Figure 13 DC Cable Connections
1
2
3
4
5
1 DC terminal bolt nut
2 lock washer
3 flat washer
4 cable ring lug
5 DC terminal
6 DC knockout hole
7 DC cable with heat shrink insulation covering the lug stem
NOTE: The DC cable lug stem must be fully insulated with the heat shrink.
12. Before proceeding, double check that the cable you have
just installed connects the positive DC terminal of the
inverter/charger to the disconnect/battery selector switch,
fuse holder, and that the other end of the fuse holder is
connected to the positive terminal of the battery.
6
7
Freedom XC 2000 - 230V Owner's Guide