9. Tighten the strain relief clamp to secure the wires.
10. Replace the wiring compartment cover (using a #2 (3.5mm)
Phillips torque screwdriver - see WARNING), if you are
finished with connecting all the AC wires in the unit.
ELECTRICAL SHOCK HAZARD
Use a torque screwdriver to tighten the captive nut panel screw to
0.56 N-m torque of force to ensure a proper earth connection and a
required tool access to the wiring compartment.
Failure to follow these instructions can result in death, serious
injury, or equipment damage.
11. Connect the other end of the wires to a circuit breaker in AC
distribution panel providing AC power to the loads.
975-0821-01-01
WARNING
Basic Installation Procedures
33