Table of Contents
Advertisement
11. Install the controller software.
•
Install the E500 controller software (on page 30).
•
Install the E600 controller software (on page 34).
12. Configure the controller.
•
Configure the E500 controller (on page 30).
•
Configure the E600 controller (on page 34).
Installing the mounting blocks
If the tiles are being installed onto a flat wall surface, determine where the mounting blocks should be
installed, and attach them to the support structure.
Warning! If not avoided, the following could result in death or serious injury.
•
External support for a display wall must be designed and implemented by a Christie qualified
installer and must comply with local area regulations and safety standards.
•
All display walls must have permanent external supports. The amount of external support
required depends on the size of the display wall.
•
A minimum of two people or appropriately rated lift equipment is required to safely lift, install,
or move the product.
The mounting blocks are available in three different configurations:
Corner blocks with one hole
1. If the tiles are being mounted on an external support structure, ensure the external support
structure is anchored to the wall and/or to the floor.
The design and anchoring of the LED display structure is not the responsibility of Christie
Digital Systems USA Inc. Contact a Christie representative for structure design options.
2. Determine where the mounting blocks should be installed.
a) Find the center of the bottom of the display area.
b) Position the mounting template with the bottom left template hole centered on the point
identified in step 2a.
c) Level and hang the mounting template on the support structure.
Velvet LED Display System Installation and Setup Guide–Apex A2L Series
020-102873-01 Rev. 1 (06-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Exterior edge blocks with two holes
Installation and setup
Interior blocks with four holes
18
Advertisement
Table of Contents
