Resetting The Breakers; Connecting The Led Tile Power Cables To The Remote Power Supply Rack Shelf; Connecting To Video Sources - Christie Velvet Apex A2L Series Installation And Setup Manual

4. Click Save.

Resetting the breakers

When too many panels are connected or too much power is sent through the Remote Power Supply
Rack Shelf, the breakers may interrupt the current flow. Reset the breakers to resume operation.
If the breakers disconnect the current, the On button is released for the affected Output.
1. Reduce the number of panels connected to the input or the amount of power going through the
input.
2. Push the On button back into place.
The current is reconnected and the output is powered.
Connecting the LED tile power cables to the
Remote Power Supply Rack Shelf
To power the Velvet Apex tiles, connect the cables between the tiles and the Remote Power Supply
Rack Shelf.
1. Connect the main power cable to the Remote Power Supply Rack Shelf.
2. Connect the cabinet power cable to the main power cable.
If the power cord supplied with your product is not long enough to connect the first display
panel in an array to the Remote Power Supply Rack Shelf module, you must purchase a power
cord of an adequate length. Christie recommends one of the pre-terminated power cables
offered as Christie accessories, or that you create a custom cable using the Christie Main
Power Cable Spool (P/N 154-122106-XX), Connector Kit (P/N 154-125109-XX), and Molex
Crimping Tool (P/N 154-124108-XX). For more information on the Molex Crimping Tool, see the
Molex documentation.
3. Plug the Remote Power Supply Rack Shelf into the building outlets in the wall or the floor.

Connecting to video sources

An LED array requires a controller to display content on the tiles.
1. Connect the data cable from the first tile in the array to the controller.
2. Connect the HDMI or DVI output from the video source (computer or media player) to the
appropriate input port on the controller.
The E600 controller behaves as two independent controllers, displaying 3840 x 2160 pixels at
30 Hz with each virtual controller. The images of both DVI1 and DVI2 input sources can be
displayed on the tiles simultaneously, but the inputs must be configured independently.
DVI1 corresponds to Ethernet ports 1-8, and DVI2 corresponds to Ethernet ports 9-16.
3. Power on the array.
After the controller is connected and powered up, the video content is available as long as the
video source is connected.
Related information
Connecting the data source cables (on page 22)
Velvet LED Display System Installation and Setup Guide–Apex A2L Series
020-102873-01 Rev. 1 (06-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
27