Connecting The Power Cables; Reinstalling The Led Modules; Adjusting The Spacing Between Tiles - Christie Velvet Apex A2L Series Installation And Setup Manual

Connecting the power cables

Connect the power cables between the tiles in the array.
Caution! If not avoided, the following could result in minor or moderate injury.
• SHOCK HAZARD! The line cord has a maximum power carrying capability. For the maximum
number of tiles that may be connected per daisy chain when connecting to the power supply,
refer to the product specifications.
1. Feed the power cables through the pass-through holes.
2. Connect the power cable to the first tile in the array.
3. Connect the power cable to the power cable of the tiles above and below the new tile.
4. Connect the cabinet power cable to the Remote Power Supply Rack Shelf.
Related information
Connecting the LED tile power cables to the Remote Power Supply Rack Shelf (on page 25)

Reinstalling the LED modules

Replace the LED modules removed while installing the tiles.
1. Connect all the carrier assembly cables onto the LED module.
2. Line up the LED module with the alignment pins in the carrier assembly, ensuring the arrow on
the back of the LED module is pointing up.
3. Set the LED module into place on the carrier assembly.
If the LED module does not fit back into place, or there is a gap between the LED modules of
two tiles, adjust the spacing between the tiles.
Related information
Adjusting the spacing between tiles (on page 23)

Adjusting the spacing between tiles

If there are gaps between the LED modules of different tiles, or the LED modules cannot be
reinstalled, adjust the spacing between the tile chassis.
To ensure the modules are at the same level across all tiles, adjust the depth of each tile using the z
adjustment screws on the backside of the tile.
Velvet LED Display System Installation and Setup Guide–Apex A2L Series
020-102873-01 Rev. 1 (06-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
23