Table of Contents
Advertisement
4. Click Read from HW.
5. Review the configuration of the tiles in the array, and modify as needed.
The cable layout for the tiles in the array is identified with an S where the first cable starts,
and the green line shows the path of the daisy chain of cables. E identifies the end of the daisy
chain.
Setting the input resolution
Set the resolution for the home page display of interface, which must be consistent with the output
resolution of the video source.
1. Log into the E500 controller software.
2. Click Screen Configuration.
3. Select Configure Screen and click Next.
4. Switch to the Sending Card tab.
5. In the Set the Sending Card Display Mode section, select the resolution of the video source
from the Resolution list.
Tile
LED012
LED016
LED019
LED025
6. Click Save.
Locking and unlocking the controller
Disable the ability to navigate the menu and modify the settings from the front of the controller.
1. To disable access to the controller menu, press and hold the menu dial and back button until
the controller screen flashes.
2. To re-enable access to the controller menu, press and hold the menu dial and back button for
approximately 15 seconds.
3. Test if the controller is unlocked by using the menu dial to navigate the menu.
If the controller is still locked, press and hold the menu dial and back button for a longer
period of time.
Upgrading the firmware on the E500 controller
When a new version of the software is released, the E500 controller must be upgraded.
1. Download the firmware file to a computer that will be connected to the controller for the
upgrade, or to a USB key.
2. Unzip the downloaded firmware file.
Velvet LED Display System Installation and Setup Guide–Apex A2L Series
020-102873-01 Rev. 1 (06-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Configuring the E500 controller
Native resolution
480 px by 270 px
384 px by 216 px
320 px by 180 px
240 px by 135 px
32
Advertisement
Table of Contents
