Table of Contents
Advertisement
6. Rotate the dial and set the vertical offset.
Testing the communication between the
controller and tiles
Verify that the array is connected to and recognized by the E600 controller.
1. Connect a USB cable between the controller and the computer running the controller software.
2. Launch the controller software and log in as the administrator.
a) Click User > Advanced User Login.
b) Login with the password admin.
3. To confirm the display is connected to and recognized by the controller, in the Local System
Info area, ensure Control System has a value of 1.
If the controller is not recognizing the tiles, select System > Reconnect.
4. Select Screen Control.
5. To confirm the controller is communicating with all tiles, select a color from the Self Test list
and click Send.
If the controller is communicating with all the tiles, each display changes to the selected color.
6. Reset the Self Test to Normal and click Send.
7. Click Close.
Reviewing the tile configuration
Review the tile configuration reported in the E600 controller software.
1. Connect a USB cable between the controller and the computer running the controller software.
2. Launch the controller software and log in as the administrator.
a) Click User > Advanced User Login.
b) Login with the password admin.
3. Click Screen Configuration.
4. Select Configure Screen and click Next.
5. Switch to the Screen Connection tab.
6. Click Read from HW.
7. Review the configuration of the tiles in the array, and modify as needed.
The cable layout for the tiles in the array is identified with an S where the first cable starts,
and the green line shows the path of the daisy chain of cables. E identifies the end of the daisy
chain.
Velvet LED Display System Installation and Setup Guide–Apex A2L Series
020-102873-01 Rev. 1 (06-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Configuring the E600 controller
35
Advertisement
Table of Contents
