Table of Contents
Advertisement
7. Remove the carrier assembly from the tile chassis, and set it face down on a padded surface.
8. Ensure all adjustment screws are flush with the outside of the tile chassis.
9. Slide the spring onto the M6 bolts so it sits on the shoulder of the bolt.
10. Attach the chassis of the first tile in the center of the bottom row to the mounting blocks in the
four mounting points.
Ensure the M6 bolts have at least three full thread engaged into the tile and are torqued to
3.55 Nm (31.42 lb.in).
11. Repeat steps 1 to 10 to install the chassis of the second tile in the row.
12. To lock the tile chassis together, push in the connection pins and tighten them by hand.
13. Use the connection pins to adjust the spacing between the tile chassis, and ensure there are
minimal gaps between the LED modules of each tile.
To determine if adjustments are needed between the chassis, or to see how close the LED
modules are, it may be necessary to fully install the carrier assemblies.
If the surface edges of the LED modules are not smooth, adjust the tightness of the bolts
attaching the chassis to the mounting blocks.
14. Repeat steps 1 to 13 for all the remaining tiles in the bottom row.
15. After the bottom row is installed and the gaps are adjusted, repeat steps 1 to 14 for the
remaining rows.
16. Reinstall the metal plates only onto the cable pass-through holes on the side and top exterior
edge of the chassis.
To allow for cable access, do not install plates along the bottom exterior edge of the array.
Related information
Installing the carrier assemblies (on page 21)
Installing the carrier assemblies
After the chassis is mounted, secure the carrier assembly to the chassis.
1. Install the carrier assembly rods onto the chassis.
Velvet LED Display System Installation and Setup Guide–Apex A2L Series
020-102873-01 Rev. 1 (06-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Installation and setup
21
Advertisement
Table of Contents
