Table of Contents
Advertisement
Installing the IR extender cable
For remote control commands to be received by the display panel, the display panel must have the IR
extender cable installed.
1. On the rear of the panel, plug the IR extender cable into the display panel.
2. Position the IR receiver so it is visible from the front of the display panel.
Installing an OPS module
To provide a network distributed processor for managing content on the display panel, install an
Change to OPS (Open Pluggable Specification) module.
The Access Series display panels only support OPS modules with a power draw of 40 watts or less.
1. On the rear of the display panel, remove the screw securing the OPS slot cover and remove
the cover.
2. Insert the OPS module into the slot, ensuring the module is fully seated.
3. Replace and secure the OPS slot cover.
4. Complete any OPS module configuration as identified in the documentation provided by the
OPS manufacturer.
Mounting a display panel
Use only the approved wall-mount kit designed for your display panel.
Caution! If not avoided, the following could result in minor or moderate injury.
TIP HAZARD! Center align the product on the stand or mount.
Ensure the IR extender cable is installed before mounting the panel. For UHD
the Wi-Fi dongle before mounting the panel.
Ensure that the signal cables are installed before mounting the panel.
If you decide to wall-mount a display panel, ensure that the wall-mount bracket is installed according
to the instructions that are included with it. The wall must be capable of supporting three times the
weight of the display panel, or be reinforced.
To ensure the mounting brackets clear any protrusions on the rear of the panel, Christie recommends
using spacers with a minimum height of 6.35 mm (.25 in).
Mounting brackets may block access to the connector ports. To ensure the preferred mount allows
access to the connectors, refer to the display panel line drawings on www.christiedigital.com for
measurements.
When mounting the UHD982-P in portrait mode, connect signal cables before mounting the panel. Ensure
the AC power input is on the bottom edge of the display panel and that the ports and OPS slot are on the
top edge of the display panel. It may be necessary to move the Christie name plate to the bottom edge of
the display panel. Use a #1 Phillips screwdriver to remove the screws from the nameplate, and to remove
the extra screws from the secondary nameplate location on the bottom of the panel.
Access II Series LCD Panel User Guide
020-001836-01 Rev.1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Installing a display panel
-P display panels, install
16
Advertisement
Table of Contents
