E600 Controller Interface And Ports - Christie Velvet Apex A2L Series Installation And Setup Manual

Inputs/Outputs
Outputs BNC (Qty. 4)
RJ45 (Qty. 4)
Genlock BNC (Qty. 2)
Control
Power
Related information
Controller limitations (on page 11)

E600 controller interface and ports

Learn about the interface and physical ports on the E600 controller.
The E600 controller behaves as two independent controllers, displaying 3840 x 2160 pixels at 30 Hz
with each virtual controller. The images of both DVI1 and DVI2 input sources can be displayed on the
tiles simultaneously, but the inputs must be configured independently.
DVI1 corresponds to Ethernet ports 1-8, and DVI2 corresponds to Ethernet ports 9-16.
Front
A Power button
B USB interface for communication with a UDISK
C LCD screen
D Menu dial for interacting with the menu
Velvet LED Display System Installation and Setup Guide–Apex A2L Series
020-102873-01 Rev. 1 (06-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Description
Supports 2-channel output and 2-channel input, with each channel supporting up to
3.125G bandwidth.
The loading capacity of one channel is up to 1920 x 1080 at 60hz. Of the two output
channels, one is primary and the other is secondary.
Supports low latency. The maximum transmission distance of coaxial cable is 100m.
4-channel Gigabit Ethernet interface, with each channel supporting up to 1G
bandwidth
Total loading capacity: 2.3 million pixels
Low latency is not supported
Support Genlock IN & LOOP
DB9 COM, USB, RJ45 (with SNMP support), USB cascading, and baud rate
115200 bps
Power switch
Power supply port: AC 100-240V~ 50/60hz
Product overview
13