Table of Contents
Advertisement
Setting the input resolution
Set the resolution for the home page display of interface, which must be consistent with the output
resolution of the video source.
1. Connect a USB cable between the controller and the computer running the controller software.
2. Launch the controller software and log in as the administrator.
a) Click User > Advanced User Login.
b) Login with the password admin.
3. Click Screen Configuration.
4. Select Configure Screen and click Next.
5. Switch to the Sending Card tab.
6. In the Set the Sending Card Display Mode section, select the resolution of the video source
from the Resolution list.
Tile
LED012-A2L
LED016-A2L
LED019-A2L
LED025-A2L
7. Click Set.
8. Click Save.
Locking and unlocking the controller
Disable the ability to navigate the menu and modify the settings from the front of the controller.
1. To disable access to the controller menu, press and hold the menu dial and back button until
the controller screen flashes.
2. To re-enable access to the controller menu, press and hold the menu dial and back button for
approximately 15 seconds.
3. Test if the controller is unlocked by using the menu dial to navigate the menu.
If the controller is still locked, press and hold the menu dial and back button for a longer
period of time.
Upgrading the firmware on the E500 controller
When a new version of the software is released, the E500 controller must be upgraded.
1. Download the firmware file to a computer that will be connected to the controller for the
upgrade, or to a USB key.
2. Unzip the downloaded firmware file.
3. Connect an HDMI or Ethernet cable between the computer running the controller software and
the controller.
Velvet LED Display System Installation and Setup Guide–Apex A2L Series
020-102873-01 Rev. 1 (06-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Configuring the E600 controller
Native resolution
480 px by 270 px
384 px by 216 px
320 px by 180 px
240 px by 135 px
36
Advertisement
Table of Contents
