Cockpit App - Otto Bock Genium Instructions For Use Manual

Cockpit app

4
Recommended tools and materials:
>
4X258 installation tool for inductive charger, 4X259 installation ring for inductive charger
1) Remove the receiver of the inductive charging unit from the holder in the knee joint with the installation tool by
turning counter-clockwise (see fig. 4).
2) Use a suitable tool to shorten the installation ring on the slotted side so that the length of the installation ring is
the same as the material thickness of the foam cover above the circular opening at the rear of the knee joint
(see fig. 5).
3) Cut a circular opening in the foam cover so that the installation ring can be attached above the corresponding
opening in the frame of the knee joint.
4) Glue the installation ring into the foam cover (see fig. 6).
5) Insert the receiver of the inductive charging unit into the installation ring using the installation tool. Ensure that
the cable is stowed away securely (see fig. 7).
6) The receiver can now be covered by a stocking or similar covering. The magnet holds the charger regardless of
this cover.
INFORMATION
If the distance between the battery charger and charging receiver is greater than 2 mm, the knee joint cannot be
charged anymore. This is indicated by feedback on the battery charger (see Page 100). However, charging
should not be a problem if there is a sock or SuperSkin between the transmitter and receiver of the charger.
8 Cockpit app
The cockpit app enables switching from basic mode into the pre-configured MyModes. In
addition, information about the product (step counter, battery charge level, etc.) can be
called up.
The behaviour of the product can be changed to a certain extent on a day-to-day basis
using the app (e.g. while becoming accustomed to the product). The adjustment software
can be used to trace the change at the patient's next appointment.
INFORMATION
The Cockpit app can be downloaded free of charge from the respective online store. For more information,
please visit the website: http://www.ottobock.com/cockpitapp. To download the Cockpit app, the QR code on the
supplied Bluetooth PIN card can be read with the mobile device (requirement: QR code reader and camera).
INFORMATION
The language of the Cockpit app user interface can only be changed using the adjustment software.
INFORMATION
The serial number of the component to be connected has to be registered with Ottobock the first time it is con­
nected. If the registration is not accepted, use of the Cockpit app for this component will be limited.
78
5 6 7
Genium 3B1-3/3B1-3=ST