Beeper; Reset Button - Moxa Technologies AirWorks AWK-1137C Series User Manual

AirWorks AWK-1137C UM
LAN 1 Green
LAN 2 Green
Serial Amber
ATTENTION
When firmware upgrade fails, the LEDs for SYS (Red), WLAN (Amber), LAN1 (Amber) and LAN2
•
(Amber) will light up simultaneously.
When the system fails to boot, the LEDs for SYS (Red) will light up along with the LAN 1 and LAN 2
•
(if there is data traffic passing through the Ethernet interfaces). This may be due to improper
operation or issues, such as an unexpected shutdown while updating the firmware. To recover the
firmware, refer to the "Firmware Recovery" section in Appendix B.

Beeper

The beeper emits two short beeps when the system is ready.

Reset Button

The RESET button is located on the side panel of the AWK-1137C. You can reboot the AWK-1137C or reset it
to factory default settings by pressing the RESET button with a pointed object such as an unfolded paper clip.
• System reboot: Hold the RESET button down for under 5 seconds and then release.
• Reset to factory default: Hold the RESET button down for over 5 seconds until the STATE LED starts
blinking green. Release the button to reset the AWK-1137C.
On
Off
On
Off
Blinking
Ethernet LAN 1 interface has connected
Data communication via Ethernet LAN 1
Ethernet LAN 2 interface has connected
Data communication via Ethernet LAN 2
Data Transmission via serial data port
1-4
Introduction