Moxa Technologies AirWorks AWK-1137C Series User Manual page 38

AirWorks AWK-1137C UM
Transmission rate
Setting
Auto
Available rates
Minimum transmission rate
Setting
0 to 64 Mbps
(0 to disable)
Transmission power
Setting
Available power
Fragmentation threshold
Setting
Fragment Length
(256 to 2346)
RTS threshold
Setting
RTS/CTS Threshold
(32 to 2346)
NOTE
You can refer to the related glossaries in Appendix A for detailed information about the above-mentioned
settings. By setting these parameters properly, you can better tune the performance of your wireless network.
Antenna
Setting
A/B/Both
*Different from 802.11n's multiple spatial data stream (2x2 MIMO), which doubles the throughput, 2T2R
transmits/receives the same piece of data on both antenna ports.
WMM
Setting
Enable/Disable
Turbo Roaming
Setting
Enable/ Disable
Description
The AWK-1137C senses and adjusts the data rate
automatically
Users can manually select a target transmission data rate but
does not support when RF type are G/N mixed, B/G/N mixed
and A/N mixed.
Description
By setting a minimum transmission rate, the AWK-1137C will
avoid communicate with weak signal wireless links to maintain
overall wireless performance and optimize the wireless
frequency usage.
Description
Users can manually select a target power to mask max output
power. Because different transmission rates would have their
own max output power, please reference product datasheet.
For 802.11bg, the available setting is from 0 to 20
Description
Specifies the maximum size a data packet before splitting and
creating another new packet
Description
Determines how large a packet can be before the Access Point
coordinates transmission and reception to ensure efficient
communication.
Description
Specifies the output antenna port. Setting "Antenna" to Auto
allows 2x2 MIMO communication under 802.11n and 2T2R*
communication in legacy 802.11a/b/g modes.
Description
WMM is a QoS standard for WLAN traffic. Voice and video data
will be given priority bandwidth when enabled with WMM
supported wireless clients.
NOTE: WMM will always be enabled under 802.11n mode.
Description
Moxa's Turbo Roaming can enable rapid handover when the
AWK-1137C, as a client, roams among a group of APs.
3-24
Web Console Configuration
Factory Default
Auto
Factory Default
0 (Disable)
Factory Default
20 dBm
Factory Default
2346
Factory Default
2346
Factory Default
Both
Factory Default
Enable
Factory Default
Disable