Moxa Technologies AirWorks AWK-1137C Series User Manual page 28

AirWorks AWK-1137C UM
The AeroMag function is inactive by default. In AWK-1137C, only the Client mode is available under the
AeroMag functionality. To activate AeroMag, set the AeroMag operation mode to Client.
NOTE You can also activate AeroMag through MXconfig, SNMP, or by using the Reset button.
Press the Reset button on the AWK-1137C five times to activate AeroMag client.
Press the Reset button three times to deactivate AeroMag (each consecutive press should be affected within
2 seconds.)
You can activate either the AP first or the Client first as the sequence of activation does not affect the behavior
of the AeroMag tool.
You can configure the following setting when AeroMag is active:
Setting
Apply AeroMag
configuration
You can also view the AeroMag Client Operating Status listed below:
NOTE Select the Auto Update option for AeroMag to refresh the client operating status every 30 seconds. When the
AeroMag Client receives information on a change in the configuration, the Auto Update function refreshes the
Client's operating status every 5 seconds.
Parameter
Find AeroMag AP
Identity Verification
Apply Configuration
AP Settings
Description
• Use the current configuration: Use the current configuration
generated by AeroMag. This option is only available if
AeroMag was already active at least once before the current
configuration change.
If you are activating AeroMag for the first time, this option
will not be available.
• Generate a new configuration: Discard current
configuration settings and search for an AeroMag AP to get
a new set of configuration settings.
Description
AeroMag Client searches for an AeroMag AP
AeroMag Client sends a connection authentication request to the AeroMag AP for the
AP to verify if the client is a Moxa device.
AeroMag AP sends a configuration that is generated for the client after the
authentication is successful. The AeroMag Client applies the assigned configuration.
Shows the AeroMag AP that this client is connected to and the assigned configuration
3-14
Web Console Configuration
Factory Default
Generate a new
configuration