Syslog - Moxa Technologies AirWorks AWK-1137C Series User Manual

AirWorks AWK-1137C UM
Configuration-related events
Configuration Changed
Configuration file import via Web Console The configuration file is imported to the AWK-1137C.
Console authentication failure
Firmware upgraded
Configuration reset to default
Power events
Power transition (On -> Off)
Power transition (Off -> On)

Syslog

This function provides the event logs for the Syslog server. The function supports up to three configurable
Syslog servers and Syslog server UDP port numbers. When an event occurs, the event will be sent as a Syslog
UDP packet to the specified Syslog servers.
Syslog Event Types
Detailed information for the grouped events is shown in the following table. Check the box for Enable logging
to enable the grouped events. All default values are enabled (checked). Details for each event group can be
found in the "System Log Event Types" section.
Syslog Server Settings
You can configure the parameters for your Syslog servers in this page.
Syslog server 1/ 2/ 3
Setting
IP address
Syslog port
Setting
Port destination
(1 to 65535)
Event is triggered when...
A configuration item has been changed.
An incorrect password is entered.
The AWK-1137C's firmware is updated.
The configuration is reset to factory default.
Event is triggered when...
The AWK-1137C is powered down
The AWK-1137C is powered.
Description
Enter the IP address of the 1st/ 2nd/ 3rd Syslog Server
Description
Enter the UDP port of the corresponding Syslog server
3-59
Web Console Configuration
Factory Default
None
Factory Default
514