Moxa Technologies AirWorks AWK-1137C Series User Manual page 50

AirWorks AWK-1137C UM
Max No. of connection
Setting
1 to 2
Ignore Jammed IP
This field specifies how an unresponsive IP address is handled when there are simultaneous connections to the
serial port.
Setting
Disable
Enable
Allow Driver Control
This field specifies how the port will proceed if driver control commands are received from multiple hosts that
are connected to the port.
Setting
Disable
Enable
TCP Port
Setting
0 to 9999
Cmd Port
Setting
0 to 9999
When the connection goes down
This field specifies what happens to the RTS signals when the Ethernet connection goes down. For some
applications, serial devices need to know the Ethernet link status through RTS signals sent through the serial
port.
Setting
always low
always high
Description
This field specifies the maximum number of connections that
will be accepted by the serial port.
1: Only a single host may open the TCP connection to the serial
port.
2: This serial port will allow the specified number of connections
to be opened simultaneously. When multiple connections are
established, serial data will be duplicated and sent to all
connected hosts. Data from hosts will be sent to the attached
serial device on a first-in-first-out basis.
Description
All transmission will be suspended if one IP address becomes
unresponsive. Transmission will only resume when all hosts
have responded.
Data transmission to the other hosts will not be suspended if
one IP address becomes unresponsive.
Description
Driver control commands will be ignored.
Control commands will be accepted, with the most recent
command received taking precedence.
Description
This field specifies the TCP port number that the serial port will
use to listen to connections, and that other devices must use to
contact the serial port.
Description
This field specifies the TCP port number for listening to SSDK
commands from the host.
Description
The selected signal will change to low when the Ethernet
connection goes down.
The selected signal will remain high when the Ethernet
connection goes down.
3-36
Web Console Configuration
Factory Default
1
Factory Default
Disable
Factory Default
Disable
Factory Default
4001
Factory Default
966
Factory Default
always high