Configuring Snapshot Settings - Honeywell HRHT4041 User Manual

•
Quality
•
I Frame Interval
•
Bit Rate
•
Audio/Video
•
Audio Format
•
Audio Source
4. Click Apply.
5. To copy the settings to one or more additional cameras, follow these steps:
a.
Click Copy.
b.
Click the specific camera(s) that you want to copy the settings to, or click All to select
all the cameras, and then click OK.
6. Click Save to save your settings.
Note: After you added IP camera to the DVR, click Refresh after configuring Encode settings
to ensure the Encode configuration is applied. Do not input parameters that is beyond the
maximum performance of your IP camera.

Configuring Snapshot Settings

To configure a camera's snapshot settings
1. Go to Main Menu  Setting  Camera  Encode  Snapshot.
If the bit rate type is set to VBR, select a value between 1
and 6.
Set to 1 S or 2 S.
Set to a value within the Reference Bit Rate range (640-
6144). To enter a bit rate that does not appear on the list,
click Customized.
Select or clear the check boxes to enable or disable audio
and/or video.
Set to G711a, PCM, or G711u (=G711μ)
Set to Local.
Configuring Camera Settings
63