Honeywell HRHT4041 User Manual page 91

Figure 9-8
2. On the Email page, select the Enable check box to enable email notifications for alarm
events.
3. Configure the following settings:
•
SMTP Server
•
Port
•
Anonymous
•
User Name
•
Password
•
Receiver
•
Sender
•
Subject
•
Attachment
•
Encrypt Type
•
Interval
•
Health Enable
•
Interval
Enter the SMTP server address of the sender's email
account.
The default TCP/IP port used for SMTP is 25.
Select check box to hide the sender's address in sent email.
Enter the user name of the sender's email account.
Enter the password of the sender's email account.
Enter the email address where you want to send the
notification. You can enter up to three email addresses.
Enter the sender's email address.
Enter the email subject.
Select check box to enable sending an attachment with the
email.
Select an encryption type: None, SSL, or TLS.
This is the interval for sending emails. Enter a time between
0 and 3600 seconds. 0 means that there is no interval.
Select check box to enable a health check. The system
sends a test email to check the connection.
This is the interval the DVR waits before sending out email
notifications after an event is detected. Enter a time
between 0 and 1440 minutes. 0 means that there is no
interval.
Configuring Network Settings
79