Starting And Shutting Down The Dvr; Starting The Dvr; Shutting Down The Dvr; Booting Up The Dvr - Honeywell HRHT4041 User Manual

Performance Series HQA Digital Video Recorder Local User Guide

Starting and Shutting Down the DVR

Starting the DVR

1. Verify that the DVR is connected to an appropriate power source.
2. Turn on the power switch on the rear panel to start the DVR.
Note The beep at startup is normal.

Shutting Down the DVR

To shut down the DVR, you must be logged in as the admin user or have shutdown
Note
privileges assigned to you. See
To prevent damage to the hard drive, follow these steps to shut down the DVR:
1. In live view mode, click anywhere on the screen to display the shortcut menu, and then
click Main Menu.
2. In the Main Menu window, click Shutdown.
3. In the Shutdown window, click Shutdown or Reboot.
4. Enter the admin password (the default password is 1234), and then click OK.

Booting Up the DVR

WARNING
The rated input voltage matches the device power on-off button. Please make sure the power
wire connection is OK. Then click the power on-off button.
To protect device, please connect device to the power adapter first and then connect the
power cable.
Always use the stable current, if necessary UPS is a best alternative measure.
Please follow the steps listed below to boot up the device.
1. Connect the device to the monitor and then connect a mouse.
2. Connect power cable.
3. Click the power button at the front or rear panel and then boot up the device. After device
booted up, the device is in multiple-channel display mode by default. If the boot up time
is in the record period, the device automatically goes to auto record mode, the
corresponding channel indicator light is on, and device is working properly.
12
Configuring Account Settings on page 129.