Configuring Automatic Maintenance Settings - Honeywell HRHT4041 User Manual

Performance Series HQA Digital Video Recorder Local User Guide
d. System automatically removes space if there is any space before or after the
newly added IP address.
e. System only checks start address if you add IP address. System check start
address and end address if you add IP section and the end address shall be
larger than the start address.
f. System may check newly added IP address exists or not. System does not add if
input IP address does not exist.
•
•
•
6. Click Apply or Save to complete setup.
• If you enabled trusted sites, only the IP in the trusted sites list can access the device.
• If you enabled blocked sites, the IP in the blocked sites cannot access the device.

Configuring Automatic Maintenance Settings

You can set up the DVR to automatically restart and/or to automatically delete old files.
To configure the auto-reboot function
1. Go to Main Menu  Setting  System  Auto Maintain.
134
Delete: Click it to remove specified item.
Edit: Click it to edit start address and end address. See
System can check the IP address validity after the edit operation and
implement IPv6 optimization.
Default: Click it to restore default setup. In this case, the trusted sites and
blocked sites are both null.
Figure 12-19
Figure 12-19.