Configuring Security - Honeywell HRHT4041 User Manual

Configuring Security

To enhance device network security and protect device data, please set the access right of the
IP host (IP host here refers to the IP PC or the server). After you enabled trusted sites function,
only the IP listed below can access current DVR.
If you enable blocked sites function, the following listed IP addresses cannot access current
DVR.
1. Go to Main menu->Setting->System->Security.
2. Enter security interface. See the picture
Figure 12-18
3. Check the Enable box.
4. Select the trusted sites/block sites.
• Enable trusted site function and then add the whitelist.
• Enable blocked site function and then add the blacklist.
5. Set parameters.
• Start address/end address: Select one type from the dropdown list, you can input IP
address in the start address and end address. Now you can click Add IP address or
Add IP section to add. System supports max 64 IP addresses.
For the newly added IP address, it is in enable status by default. Remove the √
a.
before the item, and then current item is not in the list.
b. System max supports 64 items.
c. Address column supports IPv4 or IPv6 format. If it is IPv6 address, system can
optimize it. For example, system can optimize aa:0000: 00: 00aa: 00aa: 00aa:
00aa: 00aa as aa:: aa: aa: aa: aa: aa: aa.
below.
Configuring System Settings
133