Selecting Power Supply Cords; Battery Notice - Extreme Networks 8720 Hardware Installation Manual

Safety and Regulatory Information
•
Connect the system or power supply only to a DC power source that complies
with the safety extra-low voltage (SELV) requirements in IEC 60950-based safety
standards.
Note
Because building codes vary worldwide, Extreme Networks strongly
recommends that you consult an electrical contractor to ensure proper
equipment grounding and power distribution for your specific installation and
country.
Warning
Extreme Networks power supplies do not have switches for turning the unit
on and off. Disconnect all power cords to remove power from the device. Make
sure that these connections are easily accessible.
Extreme Networks alimentations n'ont pas de contact pour mettre l'appareil
sous et hors tension. Débranchez tous les cordons d'alimentation pour couper
l'alimentation de l'appareil. Assurez-vous que ces connexions sont facilement
accessibles.

Selecting Power Supply Cords

You can purchase a power cord for your product and for your specific country from
your local Extreme Networks Channel Account Manager or Sales Manager, or you can
purchase a cord from your local supplier. Requirements for the power cord are listed in
the Technical Specifications for your product.
To locate a Sales Manager or Partner in your region, visit
partners/where-to-buy.
Note
This equipment is not intended to be directly powered by power distribution
systems where phase-phase voltages exceed 240 VAC (2P+PE), such as those
used in Norway, France, and other countries. For these applications it is
recommended that a transformer be used to step down the voltage to < 240
VAC from phase-phase, or that you make a connection to a (P+N+PE) power
distribution where voltages do not exceed 240 VAC.
All installations should confirm that the product is reliably grounded according
to the country's local electrical codes.

Battery Notice

Warning: This product contains a battery used to maintain
product information. If the battery should need replacement
it must be replaced by Service Personnel. Please contact
Technical Support for assistance.
Extreme 8720 Switch Hardware Installation Guide
Selecting Power Supply Cords
www.extremenetworks.com/
85