NEC Express5800/R320g-M4 Maintenance Manual page 226

Chapter 3 Useful Features
Item
Alert Test
*1: When Mail Alert is enabled, at least one address should be enabled.
*2: Can be specified only when To: X is set to "Enable".
*3: Up to 255 characters including alphanumeric, hyphen, underscore, period, and @ (at mark) can be used.
*4: Up to 63 alphanumeric characters excluding +, ", ?, =, <, >, #, and \ can be used.
*5: Up to 255 alphanumeric characters, hyphen, underscore, and period can be used for full domain name or IP
address.
*6: Can be specified only when SMTP Authentication is set to "Enable".
*7: When SMTP Authentication is set to "Enable", at least one of the authentic methods should be enabled.
*8: Up to 64 alphanumeric characters excluding " " blank, ",?, =, <, >, #, and \, can be used.
*9: Up to 20 alphanumeric characters excluding " " blank, ",?, =, <, >, #, and \, can be used.
*10 Can be specified only when SMTP Alert is set to "Enable".
*11: Be sure to perform Alert Test after all the parameters are configured appropriately. Alert feature may fail
depending on configuration made for network or alert receiver.
Express5800/R310g-E4, R320g-E4, R320g-M4 Maintenance Guide (Windows)
226
Separate Setting
: You can arbitrarily select the event and the address
(To:X) to alert in each sensor type.
Execute test by sending an alert by setup content and
*11
mail.
If you use Japanese keyboard and select "JAPANESE - Keyboard" at the chapter "2.2
Tips
Activating BMC Configuration", you can input underscore(_) by pressing <Shift> + <^> key.
Description
2. BMC Configuration
Default Value
－